Blog Entry 3 (Covers Week 5 + Practical 2 )
Week 5 In week 5, we were introduced to one point and two point perspective drawing. But before that we started small first. We practice sketching straight lines without a ruler and drawing circles. Then we started drawing milk carton and book in one point and two point perspectives. After all this warm up sketching, the class was asked to draw a coffee maker in either one or two point perspective. I choose to sketch it in two point perspective. Below is the picture of the sketch i drew: I know i know, its ugly🥲. In fact i don't even know if this counts as a two point perspective sketch anymore. But hey this is my first time. At least i tried🤩. As part of our report, we had to draw our eventual product in one or two point perspective also. Here is the sketch in two point perspective: Beside sketching, we were also introduced to Fusion 360. I was quite excited on starting this lesson as this is my first time creating something that can be 3D printed 😄. Fusion 360 is a software f...